All shapes on the swimlane diagram getting automatically vertically aligned after saving.
Could you please share screenshots of the error you are reporting so that we may take a better look into it?
Also, please let us know which version of the Modeler you are using.
I am using Version 22.214.171.124 64-bit
Also see the attached screenshot.
It's just happened again this morning - see attached.
It is becoming a huge problem since we have a very tide project schedule and don't have time to re-adjust the models.
Please respond ASAP.
Thank you for the response. We have a recent version of the Modeler, which should correct issues like this one. Could you please install it and let us know if your issue is solved or if it needs further assistance from our team?
This is the link to download it: https://bizagi.sharefile.com/share/view/sda9c8e31a1124d039336b4c6f060130a
All the best,
Thank you, Laura!
I keep getting an error message that "installer is running without the administrative rights" and cannot find a place where I can choose the option 'Run as administrator' as advised by the system - see attached.
Please advise, Alex
To access that option, you need to close the installer and open the file again by right clicking it and selecting the option "Run as Administrator."
Much appreciated, Laura!
It worked. Hope that issue will not reoccur...
Kind regards, Alex
Comments have been locked on this page!