Answered

Process Validation simulation problems.

Hi,

I have been using Modeler now for a couple of days and i'm still Learning. I made a very simple process using Modeler guide next to me and there is a problem that i cant understand even with the guide next to me. My Start Event is set to 1000 and the second task in the flow gets over 3000 tokens. According to the Modeler guide you need to add another Gateway and this i dont understand.

First task is Report an error, second task is Permit application, third is a gateway for Approved or Denied permit, when i run this in process validation my second task gets over 3000 tokens.

Thanks in advance.

Comments (7)

photo
1

Dear Jesper,

To best help you to solve your doubts, please share your bpm file. If you prefer, you can send it to this email: modeler@bizagi.com. This information will be treated as strictly confidential and the file will be deleted once it is no longer necessary

Regards

photo
1

Hi,

I sent my bpm file to your email adress modeler@bizagi.com.

Regards

photo
1

Dear Jesper,

Thank you to send the file. It has been analysed and tested it. To solve this issue, please upgrade to our

latest release 3.0.0.022 and apply our latest FIX according our instruction file: https://bizagi.sharefile.com/d-se994a8685054f018

Regards

photo
1

Hi,

I installed the Fix but my second and third process activity still receives more tokens than my Start event delivers.

My Start event sends out 1000 tokens and my second and third process activity receives almost 2000.

photo
1

Dear Jesper,

According the attached model to the email called "Permit to work", it is simulating correctly. Please send us the other files to analyse them

We look forward to hearing from you

photo
1

Hi,

I think you misunderstood me from the beginning, i'm aware it´s simulating correctly, though my question is and was, why is my second and third process activity receiving more tokens than my Start event delivers? I used the bizagi modeler guidelines and saw that you might need two (2) gateways for some reasons that i dont understand. So what i need too know is why and when i need to use more than one (1) gateway.

Regards

photo
1

Dear Jesper,

Thank you for your clarification. After we analysed your diagram, we confirm that it is waited result because when one token follows the "No" way, this is proceeded again by the “Apply for permit” task and the gateway, but when it follows the "Yes" way, it is the same token so that it is proceeded only one time by the “Permit approved” task.

Regards